Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateYork Mini-Split Installation: The Marietta Owner’s Guide
York mini-split installation in Marietta typically runs between $3,500 and $7,500 depending on the system size, number of indoor heads, and whether your existing electrical panel needs work. We stock York-compatible mounting hardware, line sets, communication wire, and condensate pumps on our trucks, which means most single-zone York installs in Cobb County can be scheduled within a week of your call. You usually discover you need a new installation when your York mini-split’s compressor starts short-cycling, the indoor unit freezes over in July, or a refrigerant leak has drained the system faster than a recharge makes sense.
Most Marietta homeowners call us after a technician elsewhere says the line set has a pinhole leak and the fix would cost nearly as much as new equipment. That’s a fair diagnosis more often than not, especially on York units that have spent eight or more summers pushing through Georgia humidity. Before you spend another dollar on a repair, it’s worth knowing exactly what a new York installation includes, what it should cost in this market, and how to tell whether your current unit is genuinely done.
Which York Models This Applies To
The installation guidance on this page covers York’s ductless mini-split lines most common in Marietta homes: the York LX Series, the York YVWC/YVWH wall-mounted units, and the York Affinity multi-zone outdoor condensers that drive two to five indoor heads. If you’re not sure which model you have, look at the right side of the indoor unit for a white rating plate. The model number starts with a letter combination like “YV” or “LX,” followed by the BTU rating, so a York YVWC12 means a 12,000 BTU wall unit.
One compatibility gotcha with York that matters more than people expect: older York mini-splits use R-410A refrigerant, while 2024-and-newer York units are being transitioned to R-454B. You cannot mix line sets or indoor heads between the two refrigerants, even if the physical fittings look close. If your outdoor condenser is pre-2020 and you’re replacing just one indoor head, a new head may not work with your old condenser without a conversion kit, and that kit doesn’t exist for every series. We see this confusion once a month in Marietta, usually after someone buys an indoor unit online to save money.
On the OEM-versus-aftermarket question: York OEM line sets and communication wire are worth the extra money because York’s inverter communication is proprietary in several series, and generic wire can cause intermittent “E3” communication errors that are miserable to diagnose. For mounting brackets and condensate pumps, quality aftermarket equivalents from DiversiTech or Aspen are just as reliable and often cost 20 to 30 percent less. We’ll quote you both options and tell you where it matters and where it doesn’t. Cold Harbour Heating and Air Marietta is an independent service provider, not affiliated with York, but our technicians have installed and serviced York mini-splits in Marietta long enough to know which parts have bite and which ones don’t.
Styles & brands we work with
Signs Your York Mini-Split Installation Is Failing
- Ice building up on the indoor coil during normal cooling. This usually means low refrigerant from a slow leak, a clogged condensate line forcing the coil to run too cold, or a failing EEV (electronic expansion valve) on York inverter boards. In Marietta’s humidity, ice forms fast and drips onto flooring once it starts.
- The compressor outside runs constantly but the room never reaches the set temperature. On York units this is often a failing inverter board that won’t ramp the compressor past 60 percent, or a plugged line-set filter drier starving the coil.
- The indoor unit throws an E1 or E3 error code. E1 is a communication fault between the indoor head and outdoor condenser, common when the original York communication wire has been spliced with generic thermostat wire. E3 is a coil temperature sensor fault we see on units older than seven years.
- Water leaking from the indoor head even after the filter and drain are clean. That points to a cracked condensate pan or a failed condensate pump on floor-mount and ceiling-cassette York heads. It’s one of the most common installation-related failures we replace in Marietta homes.
- The outdoor unit is alarmingly loud, like a rock tumbler running. York rotary compressors in the 9k to 18k range can get bearing wear after heavy cooling seasons, and once the compressor is noisy the best fix is usually a full outdoor unit replacement rather than a compressor swap.
None of these symptoms fix themselves, and running a York mini-split with low refrigerant or a failing sensor almost always turns a $400 fix into a full replacement. If you’re seeing one of these, the sooner you can get a qualified eye on it, the fewer zeros end up on the invoice.
Replacement Cost & What’s Included
Here’s what York mini-split installation costs in Marietta, with real numbers from jobs we’ve done in East Cobb, West Cobb, and up toward Kennesaw:
| System | Typical Installed Price in Marietta | What Drives It |
|---|---|---|
| Single-zone York mini-split (9k – 12k BTU) | $3,500 – $5,200 | Line-set run length, whether the outdoor pad needs a new base, existing electrical capacity |
| Multi-zone York system (2 – 3 heads, 18k – 24k BTU) | $5,800 – $7,500 | Number of wall penetrations, long line-set runs between floors, condensate pump count |
| Replacing indoor head only, reusing existing York condenser | $1,800 – $2,800 | Refrigerant match (R-410A vs R-454B), York communication compatibility, line-set flush |
Every installed price we quote in Marietta includes the York unit, line set, electrical whip and disconnect as needed, pad or wall bracket, new refrigerant, evacuation, startup testing, and haul-away of the old equipment. You get a written price before any tool comes out, and the number does not change at the door. That’s the Kingswell Way, and it’s not a courtesy, it’s our standard. The install itself carries our workmanship coverage, and York’s compressor warranty on new equipment runs up to 10 years when the unit is registered, which we handle for you.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
There are a couple of things worth checking before you call: confirm the breaker for the mini-split is fully on, clean the washable filters with warm water, and check that the outdoor condenser isn’t buried in leaves or kudzu. Those are safe for any Marietta homeowner to handle.
Everything past that requires a refrigeration license and specific training. A York mini-split is a sealed, pressurized system carrying several pounds of refrigerant, and the electrical side of the job is a 240-volt circuit that will not give you a second chance if you wire it wrong. The line set is flared under specific torque specs, and a single over-tightened flare is a slow refrigerant leak that will empty the system within a couple of Georgia summers. The communication wire between the indoor and outdoor units is polarity-sensitive. This is not a Saturday-afternoon project, and we say that as plainly as we know how.
If you’ve got a York mini-split that won’t run, is leaking water, or has you looking at a new installation, call (762) 240-5599. A real person answers, any hour, and we’ll give you a straight answer on what the system is doing and what it needs. Tell me what the system is doing, and I will tell you exactly what it needs – no guesswork, no runaround.
FAQs
A properly installed York mini-split in the Marietta area typically lasts 10 to 15 years. Our humid summers force these units to pull more condensate and run longer cooling cycles than in drier climates, which takes a toll on the inverter board and the coil. Units that are serviced annually and kept clean on the coil side tend to hit the high end of that range. If your unit is at year 10 with a major failure, a new install is often the smarter money. Call (762) 240-5599 and we’ll give you an honest read on whether repair or replacement wins for your specific unit.
Many York mini-split failures can be repaired, including EEV valves, condensate pumps, thermistors, and control boards, and a repair is almost always worth trying first if the compressor and coil are still healthy. Where repair stops making sense is when the compressor itself has failed or the coil has multiple leaks, because the parts and labor approach the cost of a new system. We’ll show you the repair number, the replacement number, and let you choose with full information. Guarantees on repairs are written down before we leave, and covered for a full 365 days.
A single-zone York mini-split installation in Marietta takes one full day in most homes. A multi-zone system with two or three indoor heads usually takes one and a half to two days depending on wall penetrations, attic access, and whether the existing electrical panel needs a new breaker or sub-panel. We give you a firm arrival window before the job and the technician shows up in it. If anything changes that timeline mid-job, you hear it from us directly, not from a voicemail.
We keep the most common York mini-split installation parts on our trucks: line sets in standard lengths, mounting brackets, communication wire, flare fittings, condensate pumps, and contactors. Specialty items like York-specific inverter boards and indoor coil assemblies are stocked at our local supply houses in Marietta and typically arrive the same day or next morning. If a repair or install needs a part we don’t have, we’ll tell you exactly when it will be here before you commit to anything. We also carry parts for Carrier, Trane, and Lennox mini-splits, so if you’ve got a mixed-brand home, one call still covers you.
Talk to a York Mini-Split Installer in Marietta
If your York mini-split is dead, dying, or leaking all over a new floor in East Cobb, call us at (762) 240-5599 for a free estimate on repair or replacement. We’ll send a background-checked, uniformed technician who works on York equipment regularly, arrives in the window we promised, and hands you a written price before doing any work at all. Every installation and repair is backed in writing, and if the job fails inside 365 days, we come back and correct it at no charge. That’s not a promotion. That’s how we’ve done business since 2003, and it’s the reason most of our calls in Marietta come from neighbors who had us out last year and sent you our number this year.
Written by Victor Mancini, Owner, Cold Harbour Heating and Air Marietta at Cold Harbour Heating and Air Marietta, serving Marietta and nearby areas.